Volvo ec25 blade issues

[Plantman01]

My Volvo ec25 (2004) slow putting blade to the ground but very fast lifting it back up.
It also has no power to lift the machine off the ground.
Cable adjustment is fine

Am I looking at seals in the swivel joint? Or has anyone seen this before?

Thanks

 

[V8Druid]

My Volvo ec25 (2004) slow putting blade to the ground but very fast lifting it back up.
It also has no power to lift the machine off the ground.
Cable adjustment is fine

Am I looking at seals in the swivel joint? Or has anyone seen this before?

Thanks

or blade ram seals - easier first option - edges on the one motion side may have let go

 

[CPS]

Yea id be looking inside the ram first

 

[Mick-the-fitter]

Or again, if you can swap the hoses around to check it!

 

[Plantman01]

Will try these and get back thanks

 

[JD450A]

We have a similar issue on both of our TB175's

Crap builds up on the breather side of the spool (opposite side to where the cable goes into the hydraulic block there is a cap)

Clean that out. It might work.... Beware of components within (springs etc).

 

[V8Druid]

We have a similar issue on both of our TB175's

Crap builds up on the breather side of the spool (opposite side to where the cable goes into the hydraulic block there is a cap)

Clean that out. It might work.... Beware of components within (springs etc).

used to get a similar issue with Old JakieB in the cold weather - water'd get in the caps and freeze - bit of warmth and it'd free off - IIRC there was a breather hole in the caps'd let it in