M
mart1602
Well-known member
old cubicle shed ?
JD450A
Feral as Fk 🐾
Yes,
Bottoms are a bit rotten, but more than enough bits for me to make a nice monopitch workshop and storage.
TiltyShaun
Well-known member
Lacking in headroom me thinks!!!!Think this will be grand for a shed
JD450A
Feral as Fk 🐾
I've been in it flailing round with the 7t before I took the roof off. So Should be fine.
V8Druid
do it as well as you can,but learn to do it better
HTF are you going to weld leg extensions on that then ??Think this will be grand for a shed
woodtrodes 
Shovelhands
Well-known member
I’ve seen several timber sheds that have steel stanchion bases in the ground, then plate up either side of the timber , bolts clamping it. Works well, keeps timber off the ground and away from rot. Slightly taller versions could be used to get a little more headroom if needed.
JD450A
Feral as Fk 🐾
V8Druid
do it as well as you can,but learn to do it better
take it the red one is air??
F
fred
Well-known member
we have switched to the electric husqvarna on site, takes water, 350mm blade/125mm cut. Light and no noise and stink.
Husqvarna Power Cutters K 4000
This electric all-round cutter minimises the amount of water and slurry. Unlike other electric cutters, the blade rotates forward, cutting into the material efficiently with minimum effort on the operator. K 4000 is easily adaptable for dry cutting with the Vac attachment accessory for minimal...
www.husqvarna.com
JD450A
Feral as Fk 🐾
I actually have a standing offer from a husky dealer to sell me the cordless disc cutter, chainsaw and a blower at practically cost (favours).... Trouble is charging it, and likewise keeping them charged when not in use.... Mains electric is no good for me. Means lumping the genny round.
I can go weeks without needing a saw, then need a reliable one there and then. Theory is the Air one will go with the compressor, hydraulic one with the mini digger.... problem solved for just over £100
F
fred
Well-known member
At £3.5k not really!
Husqvarna Prime K7000 High Frequency Disc Cutter
The Husqvarna Prime K7000 is Husqvarna's most powerful electric cutter ever, and is the best performing hand held cutter for indoor use. This 3-phase electric machine connects to Husqvarna's Prime high frequency power packs to deliver an increased level of power, delivering superb results when...
www.redbanduk.co.uk
J
Jimoz
Well-known member
Meanwhile I've just ordered some more pull cord for the old ts400. Snapped the other day I'm down to about an 8" pull lol
JD450A
Feral as Fk 🐾
At £3.5k not really!
Husqvarna Prime K7000 High Frequency Disc Cutter
The Husqvarna Prime K7000 is Husqvarna's most powerful electric cutter ever, and is the best performing hand held cutter for indoor use. This 3-phase electric machine connects to Husqvarna's Prime high frequency power packs to deliver an increased level of power, delivering superb results when...
That's not the cordless one... that's a big 3 phase bastard.
The "cheap" little 9" cordless is around £500 with two batteries, Very very capable.
doobin
Well-known member
No use for cutting slabs all day.
JD450A
Feral as Fk 🐾
GazCro
Well-known member
Thing is with the cordless and 110v husky they both cost the same as the petrol and weak as pi** in comparison.
R
Rob65
Well-known member
Rory,
Just watch the air saw if you don’t use it very often.
The oil inside the motor dries out and ‘glues’ the vanes in their slots so the motor does not make any power.
Sometimes a glut of diesel down the air inlet frees it up. Other times it’s a strip down job to free them up.
Rob
Just watch the air saw if you don’t use it very often.
The oil inside the motor dries out and ‘glues’ the vanes in their slots so the motor does not make any power.
Sometimes a glut of diesel down the air inlet frees it up. Other times it’s a strip down job to free them up.
Rob
JD450A
Feral as Fk 🐾
f****ng excellent advice mate, thankyou.
New toy came today courtesy of another forum member who even dropped it down (Thankyou).
Just getting to grips with it and working out a couple modifications.. But should be a excellent tool.... Hinowa HP1500 Tracked forklift/Dumper
Attachments
F
fred
Well-known member
always liked the look of those, cant find a reason or need for one but would very much like one none the less.
Footer block 1