Ripper tine

[GazCro]

Got my 205 today and it was still too big having a 55/65 opening when I wanted a 45/55 MM opening.got it fitted by welding a 12 MM spacer on end of tine and 6mm on top and some beads of weld either side of tine so my tooth not fits snuggly and having tried it,it is fine.i emailed harford again to ask if it should be a 205 or another size.they replied another size so I asked what that was and they would not tell me do a big thanks to kirstie for that.ill remember that next time I’m after something.pics show my tooth in middle,small one is a 200 and big one is 205
nick...View attachment 38607View attachment 38608

Aside from the difficulties you're having sourcing or even being told which one you need it's a bit like @Routy56 and his dumper tyres where i look and think there's life in the old tooth yet.

 

[Furniss]

Quelle histoire

Got my 205 today and it was still too big having a 55/65 opening when I wanted a 45/55 MM opening.got it fitted by welding a 12 MM spacer on end of tine and 6mm on top and some beads of weld either side of tine so my tooth not fits snuggly and having tried it,it is fine.i emailed harford again to ask if it should be a 205 or another size.they replied another size so I asked what that was and they would not tell me do a big thanks to kirstie for that.ill remember that next time I’m after something.pics show my tooth in middle,small one is a 200 and big one is 205
nick...View attachment 38607View attachment 38608

Quelle histoire

 

[Quattromike]

HMF Cranes,

That could be the problem, I`m having

I find HMF to be rip off merchants, we were getting them to come and service and loler our crane but on time the guy appeared and serviced it but said he couldn't change the tank filter because of how the tank was mounted. It's been like how it is for the three years we've had it so how it's different now I don't know. Then said the check valve for the telescopic boom is leaking and needs replacing, he would get a price for it. Then turns out because of this he didn't bother doing a loler until it was rectified. The price for a check valve was circa £750 plus half day labour for them to come and fit it. Then we would have to pay again for the revisit to carry out the loler. It immediately thought there something not right with this crowd so went to look at it myself and sure enough it was a little oily around the check valve but I'd never seen it like that before so under closer inspection it turns out one of the fittings was slack so I nipped it up then was fine. Since then we just get Bureau Veritas to do loler and at half the cost.

 

[Bri963]

HMF Cranes,

That could be the problem, I`m having

Just round the corner from us but I’ve never dealt with them.

 

[CPS]

Got my 205 today and it was still too big having a 55/65 opening when I wanted a 45/55 MM opening.got it fitted by welding a 12 MM spacer on end of tine and 6mm on top and some beads of weld either side of tine so my tooth not fits snuggly and having tried it,it is fine.i emailed harford again to ask if it should be a 205 or another size.they replied another size so I asked what that was and they would not tell me do a big thanks to kirstie for that.ill remember that next time I’m after something.pics show my tooth in middle,small one is a 200 and big one is 205
nick...View attachment 38607View attachment 38608

I think you need a 101 I think there called... il check the workshop in the morning

 

[Left hooker]

Handy chart for you

 

[Left hooker]

This one has part number
6y3222