JCB 537-135 wont tally in (SOLVED)

[jasonplantuk1]

hi guys. i have a JCB 537-135 telehandler, Year: 2000. It wont tally in, tallying out perfectly, 2 sections obviously, i removed the ram of the big section and it slid in on its own, so the ram/rams are at fault. anyone seen this before or have any idea what it could be? machine is putting up the pressure as i took the 2 valves out of the cylinder block at the bottom of the top ram and oil everywhere. Ram seals away? Valve issue? hydaulic pump itself? otherwise shes doing absolutely everything else perfect. any help much appreciated! Thanks, Jason (07756520878)

 

[JD450A]

Does the lever work?

 

[Mogman]

Sounds like check valve

 

[Mick-the-fitter]

Do the legs work? And lock out?

 

[jasonplantuk1]

Do the legs work? And lock out?

Yes the legs work and lock out. arm goes out full. everything working right down to the window wiper. just not tallying back in

 

[jasonplantuk1]

Does the lever work?

Yes the machine is labouring/moaning when i pull the lever. Its like shes trying

 

[Mick-the-fitter]

Check all your where pads. By your right shoulder, on top of the ram is a block with valves, when cold and on the ground, remove both valves check the o rings, normally the middle ring on the larger valve will be split, send photos

 

[jasonplantuk1]

Check all your where pads. By your right shoulder, on top of the ram is a block with valves, when cold and on the ground, remove both valves check the o rings, normally the middle ring on the larger valve will be split, send photos

Yes it was the seals in the ram block, the small valves, replaced all seals and its working perfect. thankyou guys!

 

[Bri963]

Between this and the Bobcat, you’ve got some dodgy kit.

 

[jasonplantuk1]

Between this and the Bobcat, you’ve got some dodgy kit.

Its like they know to all go wrong at once!!! lol

 

[6feetdown]

Its like they know to all go wrong at once!!! lol

I know that feeling