it would be so hard to tell ........its very minimal .....but when io took delivery and tracked it top the drive , I had to occasionally make an adjustment to the left as it was very slightly tracking to the right a tiny bit more .....you know like when your car needs its tracking adjusted as it won't steer in a straight Line but only slightly
Potentially one track is slightly stretched, or a motor is worn, or a linkage to a valve is slightly worn. Tbh Drain the gear oil out of the drive motor gearboxes and refill, if there is oil in them then happy days and don't worry about it too much. New ones quite often will be exactly the same.
I think on the Kubota k008-3 I read they are sealed
cool one of the tracks has a tear in it where it has hit a rock or something ....hopefully that is the cause
To elaborate, if one track is too tight it will slow it down.
That can be down to a slightly bent lever or stretched linkage. There’s a stack of rods from the levers down to the spools. As long as the spool is getting full travel that won’t be the cause.
K008-3 and U-10 are sealed. No level plugs.
Bad times
I'd normally say too many but the other people commenting know there s**tIt looks like there are a few cooks on this broth!
Hi ..they are 180x072x37 ....thanks for helping
