No not seen it...have a job keeping on top of all the good YouTube channelsdid you watch this one @Lancs Lad .... some lovely 'garage engineering' in it .... the guy can really drive his machine tools .. some of his hand work is 'interesting' though
he got it running in the end ...... total loss oiling system though I'd guess .......... via the cam'd be my guessNo not seen it...have a job keeping on top of all the good YouTube channels
Will watch later looks good
Blackwood apparently! Surely he's breaking the law driving whilst using a mobile !If only he’d used the pallet forks
10.28 for the crimping pliers
.... drool over this one ......... I almost bought a GT40 kit in my late 20s .. was £9k back then - a lot of bucks .... then'd've needed to spend close on the same again on all the bits .. was a real hard decision ... not to ... always loved them and drive shaft extensions ...... far too much time on their hands ..... clever little sods though Don’t think that’s going to come undone!think these blokes have had some practise
Queueday oop @Lancs Lad
this is some job
and now the 'flip side'
the discs
The guy in the grey tee shirt makes a better door than a windowthink these blokes have had some practise
I'd be guessing the socket was already on the rope Mog ...... the one that was shown was almost certainly a spare ..... be like trying to wrestle a 3ft octopus into a test tube, tentacles firstThe guy in the grey tee shirt makes a better door than a window
would like to of seen them put all the frayed end in to the socket though
impressive ...... very little fell far from the pond .... some pile of hard core
had heard of him, but the write up is fascinatingAnybody remember this chap. Was fairly local to my area i believe
Blaster Bates - Wikipedia
en.m.wikipedia.org